The FET target interface provides access to MSP430 targets via TI's parallel port to JTAG MSP430 Flash Emulation Tool. This target interface supports program loading and debugging.

Connection property group

Enable Regulator

Specifies whether power is to be supplied to the target.

Identify

If set the device will be identified on connect. If not set the Target project property setting of the current project in the current build configuration will be used.

Parallel Port

Specifies which parallel port to use.

Parallel Port Address

The base address of the currently connected parallel port.

Parallel Port Sharing

If true other devices can access the parallel port whilst connected.

Release JTAG

Release the JTAG signals when Reset, Start Without Debugging or Stop Debugging is used.

Current property group

Device Type

The identified device type.

Emulation property group

Clock Control

The level of debug clock control supported by the device.

Emulation Level

The debug capabilities supported by the device.

Loader property group

Erase All

If true erase all memory. If false just erase the pages that are to be programmed.

FLASH Block Write Enabled

If set to Yes, the flash is programmed in block mode rather than word mode. Block mode flashing is approximately twice as fast as word mode programming.

Verify FLASH Erase

If set to Yes, FLASH memory will be checked after an erase to determine if operation has succeeded.

Verify FLASH Writes

If set to Yes, FLASH memory will be checked after a write to determine if operation has succeded.