Drivers for an ITead Studio IDB02 with an ITDB02-4.3 LCD module.
Using the ITDB02-4.3 is unreliable with the ITDB02 v1.2 shield and is incompatible with the ITDB02 v2 shield, so you need to connect the ITDB02-4.3 module to the SolderCore headers directly.
Unfortunately, driving the LCD in 16-bit mode utilizes all the pins on the SolderCore, leaving nothing free. A disappointing consequence is that you cannot use the SD card interface, nor can you use the touch screen controller.
All correct at time of writing, but as always, manufacturers love to move things around on their website.
This code has been tested using a SolderCore: