Driver for InvenSense IMU-3000 gyroscope.
All correct at time of writing, but as always, manufacturers love to move things around on their website.
This code has been tested using a SparkFun IMU-3000 breakout:
This was wired to a CoreProto and plugged into a SenseCore:
And finally installed on a SolderCore:
|Bandwidth (Hz)||8,000 to 31.25 in 256 division steps.|
|Range (dps)||250, 500, 1000, 2000 (default)|
|Communication||up to 400 kHz (I2C)|
|IMU3000_I2C_ADDR||IMU-3000 8-bit I2C address selected with AD0 signal|
|imu3000_initialize_i2c||Initialize sensor on I2C bus|
|imu3000_read_die_temperature||Read die temperature|